Differences

This shows you the differences between two versions of the page.

--- denon_prime_console [2024/05/13 00:23] – ounsatn
+++ denon_prime_console [2024/05/17 14:14] (current) – ounsatn
@@ Line 244: / Line 244: @@
 Like below :
-{{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_18.JPG}}
-Connect Prime to your computer via US, and launch FirmwareUpdater.exe, then if your prime is detected you can run update.
+Connect Prime to your computer via USB, and launch FirmwareUpdater.exe, then if your prime is detected you can run update.
 {{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_19.JPG}}
@@ Line 255: / Line 255: @@
 Now launch a putty, put ip of the prime with port 230.
-{{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_20.JPG}}
+{{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_21.JPG}}
 login with root / pwd : prime
 Tadaaaa your in !
-{{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_21.JPG}}
+{{http://dnttalo.cluster029.hosting.ovh.net/Pictures/PrimeGo_Console_22.JPG}}
+To finish, i tried to enable sshd to be run at the startup in the firmware but each times i tried , it failed.
+I should ask on AkaiF/MPC Moddings Groups how it's done, however with telnet it's working well.
+Of course after the telnet connection you can launch ssh
+<code>
+## edit /etc/ssh/shd_config
+## put PasswordAuthentication yes
+## put PermitRootLogin yes
+## and then launch ssh daemon
+systemctl start sshd
+</code>
+As we put telnet in the prime service, if you restart or stop prime service it will kill your telnetd.
+So launch an ssh session before restarting/stopping engine.service via systemctl otherwise you'll loose control of the beast.
+If needed here is my img file , tested on my prime go and working, however use it at your own risk i cannot be responsible for bad usage.
+[[http://dnttalo.cluster029.hosting.ovh.net/Akai/PrimeGOTln/]]