debug_port
This is an old revision of the document!
To get console access via UART on Akai devices you have to proceed like on the pictures below
On my AKF i have 6 pins, sometimes on MPC there is less pins. Use an USB/TTL converter to avoid damage on your board. You can use this one as on the photo : USB-TTL Converter
Connect like this :
** GND from Akf to GND on usb stick
* Rx from Akf to Tx on usb stick
* Tx from Akf to Rx on usb stick
debug_port.1746376015.txt.gz · Last modified: 2025/05/04 18:26 by ounsatn